/* Copyright 1992 by the ANSI figForth Development Group This is the machine-specific part for a SPARC */ #include "32bit.h" #if !defined(USE_TOS) && !defined(USE_NO_TOS) #define USE_TOS #endif /* direct threading is probably faster on the SPARC, but has it been tested? Therefore, DIRECT_THREADED is not defined */ #ifdef DIRECT_THREADED #ifndef WORDS_BIGENDIAN #error Direct threading only supported for big-endian machines. /* little endian SPARCs still store instructions in big-endian format, so you would have to reverse the instructions stores in the following */ #endif #ifdef undefined /* according to the SPARC V9 architecture manual, we have to use flush, but as V2.20 does not recognize the opcode */ /* assuming size = 8 */ #define CACHE_FLUSH(addr,size) \ asm("flush %0; flush %0+4"::"r"(addr)) #endif /* PFA gives the parameter field address corresponding to a cfa */ #define PFA(cfa) (((Cell *)cfa)+2) /* PFA1 is a special version for use just after a NEXT1 */ /* the improvement here is that we may destroy cfa before using PFA1 */ #define PFA1(cfa) PFA(cfa) #ifdef undefined #define PFA1(cfa) /* PFA(cfa) */ \ ({register Cell *pfa asm("%o7"); \ pfa+2; }) #endif /* CODE_ADDRESS is the address of the code jumped to through the code field */ #define CODE_ADDRESS(cfa) ({unsigned _cfa = (unsigned)(cfa); \ (Label)(_cfa+((*(unsigned *)_cfa)<<2));}) /* MAKE_CF creates an appropriate code field at the cfa; ca is the code address */ /* we use call, since 'branch always' only has 22 bits displacement */ #define MAKE_CF(cfa,ca) ({long *_cfa = (long *)(cfa); \ unsigned _ca = (unsigned)(ca); \ _cfa[0] = 0x40000000|((_ca+4-(unsigned)_cfa)>>2); /* CALL ca */ \ _cfa[1] = *(long *)_ca; /* delay slot */}) /* this is the point where the does code starts if label points to the * jump dodoes */ #define DOES_CODE(label) ((Xt *)(CODE_ADDRESS(label)+DOES_HANDLER_SIZE)) /* this is a special version of DOES_CODE for use in dodoes */ #define DOES_CODE1(label) DOES_CODE(label) #ifdef undefined #define DOES_CODE1(label) ({register Xt *_does_code asm("%o7"); \ _does_code+2; }) #endif /* this stores a call dodoes at addr */ #define MAKE_DOES_HANDLER(addr) MAKE_CF(addr,symbols[DODOES]) #define DOES_HANDLER_SIZE 8 #define MAKE_DOES_CF(addr,doesp) ({long *_addr = (long *)(addr); \ unsigned _doesp = (unsigned)(doesp); \ _addr[0] = 0x40000000|((_doesp-8-(unsigned)_addr)>>2); /* CALL doesp-8 */ \ _addr[1] = 0x01000000; /* nop */}) #endif